Rubber Duck's Jig

M Quinton

Message 22033 · 30 Jul 2000 23:26:07 · Fixed-width font · Whole thread

Previous message: What will they think of next... (S.M. Gent)
Next message: What will they think of next... (Dewdney Andrew)
Previous in thread: Rubber Duck's Jig (奥村 尚子)
Next in thread: Rubber Duck's Jig (M Quinton)

----- Original Message -----
From: Gayle Hoepner <xxxxxxxx@xxxx.xxx>
To: <xxxxxxxxxx@xx.xxxxxxxxxx.xxx-xxxxxxxxx.xx>
Sent: Friday, July 28, 2000 11:37 PM
Subject: Rubber Duck's Jig

> Can anyone help me with Rubber Duck's Jig? I have two cribs, neither of
> them original, and they don't agree.
>
> First set of instructions:
> bars 1 - 8 3C petronella turns to R and set; repeat that to finish
> on opp sides.
> meanwhile
> 2C and 4C set and petronella turn to the right to
> the next corner position; repeat
> to finish in the other couple's position, on opp
> sides.
> 1C and 5C set and cross over by the R.
>
>
> Second set:
> bars 1 - 8 3C petronella turn to R and turn 3/4 by R; repeat that to
> finish back in own place.
> meanwhile
> same as above.
>
> In this case, second set seems to work better, because 3C is turning in
> the middle while others are petronella turning to next place.
>
>
> First set:
> bars 9 -16 3C set twice, turn by L once round and a bit more ready to
> .........
> meanwhile
> 1C with 4C and 2C with 5C, dance RH across once
> round, then chase CW 1/2 way round
> the set; finish on own sides, 1 & 5C in eachothers
> places, 2 & 4C in original places.
>
> 17-24 3W with 2C, 3M with 3C dance L shoulder reels of three
> across the dance.
>
> Second set:
> bars 9 -16 3C set twice, turn by L 1-3/4 ready to .........
> meanwhile
> same as above
>
> 17-24 3W with 4C, 3M with 2C dance L shoulder reels of three
> across the dance.
>
> This time, first set works better, because 3C finish on their own sides
> at the end of the reel.
>
> The first set of instructions is from a dance program; the second set
> is from my memory, written down fairly soon after I danced it. But that
> was several years ago and now I don't remember.
>
> Thanks,
> Gayle Hoepner
> Ames, Iowa
I have been fascinated by the name Rubber Duck's Jig. Is it an 8x24 bar jig
or did you leave out the last 8 bars, and if so what are they please.
Mary
Walmer Kent
>
>
> --
> Gayle Hoepner <xxxxxxxx@xxxx.xxx>
>
>

Previous message: What will they think of next... (S.M. Gent)
Next message: What will they think of next... (Dewdney Andrew)
Previous in thread: Rubber Duck's Jig (奥村 尚子)
Next in thread: Rubber Duck's Jig (M Quinton)
A Django site.